The Zenith/Bose set with chinese cabinet
 

Deciding whether or not to fix. Fired it up for the first time since I picked it up. After running awhile, didn't look to bad. Sound was good. Pic is raised from the bottom and top is stretched. Is there a certain set of caps I need or will I have to just check to see? Anything else an issue?

That's sweet. Definitely fix it. Unique cabinet, Bose...that's a rare set.

Yah, that's a keeper. Probably a simple fix.

I like it. Unique. Try to get it repaired.

Change EVERY electrolytic cap on the vert module & check for
cold joints. The vert IC has been NLA for yrs so you dont
want it to blow over a few bucks worth of caps!
Also go over the power supply & HV modules for cold joints &
swollen 'lytics.
CRT looks fair with some red bleeding. Running it & adjusting
it "down" a little will help.
This is a "Digital System 3". after the video detector everything
is digitalized for processing. This model is VERY rare & the
most expensive in the line. If a 27" would have been $1,500- $2000.
A non Bose 27" table model DS3 was $1000......
Please keep it & keep it intact !!!!

BTW "digital" sets like this using the ITT chip set were also sold by
NEC, Toshiba Panasonic & maybe MGA. Zenith sold by far the
most from 20" to projection sets.

73 Zeno:smoke:
LFOD !

I'll definitely be fixing then. Soon as I get into it, ill go over everything.

Looks like pincushion issues too.

...

With so many projects, I'm just now getting around to this one. September 1986 model. I took these three pics. If anyone can point me in the right direction of what needs replacing and what needs touching up. One will be checking under the plate below for caps, etc. Not sure where the vertices section is on this one.

...