View Single Post
Old 07-10-2016, 12:50 AM
Boobtubeman's Avatar
Boobtubeman Boobtubeman is offline
<---WANTED: Motorola 17P6
Join Date: Jun 2007
Location: Woodland Ca.
Posts: 842
Went as far as running without the zener and no change. The to-220 tests fine on the diode setting on my meter so its back in circuit. Double checked my voltages and all the + and- 5 volts are present. The 12v pin only gets as high as 3v before it falls due to the instant shut down.. Swapped the 1000uf@10v e-caps with an exact set of used ones. I dont have an ESR meter, I am using a centech #69096 digital meter if that helps reference my tester and its functions...

The dc-dc sub board mentioned gets to 14v before the shutdown...

any other culprits on this board i need to check??

Reply With Quote