|
Pin 8 and 9 to ground should measure close to zero - and you have resistance. Taken from Socket (above) or pins (below), they should both be close to zero.......I'd start there. Runs to the eyelets....simple trace. Assuming the solder connection is good - bigger the blob, better the job does not apply here - go for a clean, shiny fillet.
__________________
Brian
USN RET (Avionics / Cal)
CET- Consumer Repair and Avionics ('88)
"Capacitor Cosmetologist since '79"
When fuses go to work, they quit!
|