Quote:
Originally Posted by old_tv_nut
Are you sure it's worn off, or could it be deliberately not applied in those areas? It should not be applied too close to the high voltage connector because of the possibility of arcing. (Of course, what is there should be contiguous so it's all grounded.) In any case, it's OK to wait until you have the set running to see if there is any problem. Aquadag (the full name) can be purchased and applied easily, but I wouldn't bother until you're sure you need it.
|
Well I did notice it is not applied near the high voltage connector but I was thinking it was worn off due to the unevenness of it all. Toward the top it's chipping and peeling. After I recap it then perhaps I will see where I am with this aspect.