Quote:
Originally Posted by Dave A
Chassis is all recapped years ago and looked at by Dave Johnson who anointed it in its original operation. Now to today.
I did the tube pulls and no appreciable change. Same startup and then falls back. Tubes check and all is well. A look inside shows no anomalies.
I ran it with the Aurora adaptor startup signal minus the wheel and the pic seems to be doing what it is supposed to do with a massive RGB flicker at the proper rate.
The Philco does seem to have a problem. Any adjustment of the vertical only seems to send the roll downward. It reaches a sweet spot and then goes down again. No upward roll. Not sure what this is and if it is related to the V pulse signal. A Sunday night test only. Stay tuned.
|
is the motor completely free, a spec of wD40 at the front and rear of the motor where the bushings are. Just a thought.