Quote:
Originally Posted by Username1
And that scope is fully an X-Y mode scope, just put both vert. and horiz. inputs at the top left and right to ext. and then attach something to those inputs and you have X-Y display. (Again be careful with the grounds!) Some of those things might even have a Z cutoff. I have one like that made by one of Tektronix's little brothers.
|
Here's what I'm trying to hook up to it:
https://www.sparkfun.com/products/9306
I tried it before I recapped the scope, but it was a disjointed image. Haven't tried it since, as I was under the assumption that it wouldn't work. On the PCB, there's an X, a Y, and a ground. Do I ground it to the scope, and if so, where?