View Single Post
  #6  
Old 07-17-2016, 07:38 PM
SwizzyMan's Avatar
SwizzyMan SwizzyMan is offline
Restoring an admiral c322
 
Join Date: Apr 2015
Location: Side Lake Mn
Posts: 886
Quote:
Originally Posted by Phil Nelson View Post
Definitely do not rejuvenate the CRT at this point. Too easy to kill the tube, and what you're seeing on the screen may be normal for a CTC-4 that's chock full of bad caps. A working television will tell you more about a CRT's condition than any tester.

I agree with old_coot88, that pop sound could be arcing, and the cutout in the CRT metal retaining ring is an obvious place to look. If you run the TV briefly in a completely dark room, you might even see the zap occur along that dark track seen in the photo.

When I installed a glass CRT in my set, I made a smaller cutout in the ring, but I also covered the nearby edges with cambric insulating tape rated for 90KV. More about all that in:

http://antiqueradio.org/RCACTC-4ColorTelevision.htm

You are right to think of this as a long term project. Be patient and it will all get done. CTC-4s don't come along very often, so enjoy working with this one while you can.

Have fun!

Phil Nelson
Phil's Old Radios
http://antiqueradio.org/index.html

P.S. What's in the little metal project box? Looks like a relay and a tube on top . . . ?
Thanks Phil! I'll try and keep watch on that area suspect to arcing. The little project box is actually a soft start module. It lets the tubes fully heat up before applying any voltage to them. The same concept is shared on your CTC-7, but this was one of the modifications the previous owner installed. I think its pretty nifty!
__________________

Admiral C322C2 Regent (Restoring)
RCA CTC-7 Pensbury (Restored)
RCA CTC-5 Westcott (Restored)
CRA CTC--4 Director 21 (Restoring)
Reply With Quote