[Sealtest]

Hey all, today is not my day. All I wanted to do was adjust my favorite Tv but I had an accident with it. The coax hookup to my signal generator fell into the chassis and bridged between the chassis and the AC line. Or at least that's what I think. I am really not sure..

Anyways I found a burnt resistor but I can not read the value. With a meter it reads arounf 200ohms so I am guessing there is some other issue. This is my favorite and best tv so I really would like to get it going. So far there has been luck with finding a manual.


Also no luck setting the convergence really, but now this set is a bit too dead to do that with.