View Single Post
  #9  
Old 10-23-2017, 07:41 PM
Crist Rigott Crist Rigott is offline
VideoKarma Member
 
Join Date: Oct 2015
Location: Waxahachie, TX
Posts: 1,506
Thanks for the good comments guys. I noticed that my BK 467 tester needs calibration on the filament scale. When the tester reads 6.3V, the CRT is only getting like 5.7V under load. I didn't check the filament reading with no load.

So when I cooked it at "7V" it was really close to 6.3V and I still got into the green. I'm thinking now especially after everybody's comments, the CRT will provide good service.

Stay tuned for the restoration.
Reply With Quote