View Single Post
  #47  
Old 11-06-2017, 11:50 PM
Crist Rigott Crist Rigott is offline
VideoKarma Member
 
Join Date: Oct 2015
Location: Waxahachie, TX
Posts: 1,506
I then got to work on re-stuffing the E-Cap (C2). I'll use my usual method of cutting off the base right at the bottom of the can, clean it all out, true up the parting surfaces of both the base and the can. I enlarged the hole in the middle of the base to 5/32. Then I epoxy a 1 inch tall piece of PVC pipe to the base. Making sure there is no epoxy on the outside which will interfere with a good seam where the base and can meet. Tomorrow I'll add the replacement E-Caps.






Last edited by Crist Rigott; 11-07-2017 at 12:03 AM.
Reply With Quote