|
Hi miniman82,
I was just about to send off an email to Solidesign, but if you're willing to send me a set, I'll do my best to put them to good use. Great to see how folks here share resources and tips.
Quick question here for anyone who has worked on these or faced a similar situation on a different set -- Is there a preferred way to get the safety glass off the plastic CRT mask? Looks like the original rubber or expanded foam seal liquefied at some point and ran downward a little, and then very helpfully turned to stone with quite good adhesive properties (see picture). I'm hoping not to damage the paint on the front of the mask, which might happen if I simply try to pry it apart. Maybe a little (but not too much) heat?
Tom
|