Well, it looks like I have to repair both the BK 467s. I glad my BK-445 does proper tests and has a big, easy reading scale. Also it only cost $5
On the first, the heater supply is dead, won't light a 25BAP22 and the meter doesn't read any filament voltage. Line volts read OK and the G1 seems to adjust OK but then quit. PCB shows that some parts were changed.
The second one has good heater supply but the G2 supply is low, so that switch set on high and G2 controls set at the first division per instructions, R-G-B on a strong color tube reads in the middle of "bad" range.
I got the first in a lot of test equipment from a local shop and second one at a swap meet with about a dozen CR Adapters for $20, so I expected this.