Quote:
Originally Posted by zeno
On this set if the tubes are lit but its dead the switch is OK.
Look at the ground posts like mentioned in my prev post.
Also get a long plastic stick & lightly push on things to narrow down the area
the problem is in.
After that you will need a schematic & meter but it should be easy to find.
good luck
Zeno 
LFOD ! |
Hold the phone. I think I licked it. What happened was this was a case of bad soldering. The problem was that one of the wires came loose. I couldn't see it due to the electrical tape. That's why if you watch the video I posted earlier in the thread it shut on and off as I rocked the set, as the wire was touching and then untouching. Well, I guess I learned a valuable lesson.