Thread: Rca ctc-5h
View Single Post
  #20  
Old 04-14-2018, 02:27 PM
Tony V's Avatar
Tony V Tony V is offline
VideoKarma Member
 
Join Date: Feb 2003
Location: Brookneal, VA
Posts: 888
What i did on one of mine was remove the mask to get at the original mounting bolts and replaced them with longer ones. I then reused the plastic housing which slid back in place as it is only slid out about an inch and a half from the original crt position hence the longer bolts. Of course i had to take a hole saw to the side of the housing so i could hook up the anode lead. The outer magnets and hardware were removed from the mask. The good thing about this route is everything can be put back original if a good 21axp22 is found or if the old one can be rebuilt. The chassis had to be slid back an inch because two tubes were right up against the housing but this might not be an issue depending on what cabinet you have.
Reply With Quote
Audiokarma