|
Thanks for teh quick reply,,, Guess I dont have this forum set to send Email when a post is updated,,,
I couldn't get a couple of teh plugs out of teh board to get it out to teh bench, but there is enough slack to flip it over and work on in place... This board is over a foot wide and is only supported on teh sides, in slots, Its gotta bend and break connections/traces sooner or later,,, If I can identify teh IC, I'll try to reflow it,,, I should have a few low voltage caps, so I'll see about that one also...Maybe then it will last long enough to find a replacement set...
Thanks again for teh info/help...
Regards,
John
|