|
I'll have no problem working with the SMD's.
The boards are almost fully designed. Some are just a little taller which won't be a problem. I designed them using 1W resistors, hence the reason they are a little taller.
Parts are on order for them.
I still don't know if 200V will be enough for the 82pf cap in K6. It is connected to the plate (pin 3) of V4, the Sync Separator tube. The schematic shows 70V on pin 3. But then there's a resistor R39 at 150K connected to the 265V supply. The 82pf cap is on the resistor side and plate of V4 of that 265V. I'm not smart enough to be able to figure out what the voltage should be except that it should be at least 70V.
|