|
.
Can't you find a 10:1 transformer of the same physical size no matter what it's
original purpose was, and stick it in there.... (Insulation should be compatible
with the voltage in the circuit of course...) Maybe you have to add a cap
across pri.or sec. to raise, or lower output as needed by tuning it with
the cap..... Might even be a good idea to get a 11:1, or 12:1 that
way you can attenuate output down as needed, easier to do than
ending up with a signal too small from a poor match with 10:1.
For that matter an LC circuit in your mosfet circuit output might just
get it to "ring' a little higher p-p and do the job.....
It's a nice circuit you made, I was wondering what you were going to do
about the phase shift in your circuit when you first posted it....
Anyway - Interesting poop.....
.
__________________
Yes you can call me "Squirrel boy"
Last edited by Username1; 01-27-2024 at 11:56 PM.
|