|
well I decided to try a less full on approach 1st. May end up doing the full job but its really just a learning thing so 1st is what can I do with out going all out.
What I did was wet sand the bad areas on the top of the front fenders. used 1000 grit and just hand sanded. wipe down with some cleaner, then shot some rattle can clear just using a piece of cardboard as a moving mask, feather in to the good part down the side of the fender. Its about 1000% better considering where it was.
I will get some polishing compound and work the feathered part just for grins.
|