Quote:
Originally Posted by dieseljeep
Some of those resistors look a little tired.
BTW, what procedure do you use to remove all the old leads and solder from the terminal strips? On occasion, I use a desoldering iron like used on PC boards.
As usual, amazing work!
|
I usually clip the component free leaving about 1/4 to 3/8 inch on the terminal strip. I then use solder wick to get as much solder off. Then I remove the old leads and again solder wick for final solder clean up. Then using a cut down acid brush, I brush with some acetone to clean off the old resin and make the terminal nice and clean. Then on to installing the new components.