[Username1]

Ha Ha on the better ideas...

Mine is card board, and the glue between the felt and card board easily dries, and a layer
of cardboard comes off with the glue on it.... I think I would have to seal it with some
magic chemical that penetrates the cardboard. I may just get an after market thing
and put it up, so what if it don't match completely..... I used a office swingline staples
and just pushed them into it with a little elmers on the ends to keep it in there....
Sometimes I push them in and then use two pliers and twist the staple to make it harder
to fall out... But it only lasts a year then falls down again.... It's not really something I'm
worried about But you know one day I'm just gunna have it get under the right piece of
skin and then I'm gunna have to fix it.....

Don't JC Whitney got some after market fix for yer car....?


.