Quote:
Originally Posted by Yamamaya42
The biggest question that I always had was exactly WHERE to place the parts on the neck of a 21fjp22(a), convergence clover, ETC, cause of the internal markings, you can't see where it goes like you can on later rectangular delta types, on which you can very easily see where to put it...
|
So very true! With my 21AX, I did a lot of fiddling, looking for the position with maximum effect and then comparing with the un-dimensioned illustrations in the service literature, readjusting, round and round. The results I get for both purity and convergence on this rebuilt tube suggest to me that the replacement gun may be slightly rotated from nominal position.