|
Once the table is turned on, the arm goes freely from side to side for a bit, and then it has some resistance. I have the pressure fairly heavy. So there is a bind somewhere, or something is not timed correctly in the sweep.
I tried what someone else has recommended, and place the balance arm all the way to the right, over the tone arm, then turned the platter on so it spins, then I used my hand to stop the motion, and reverse the direction until I felt a hard spot of resistance. That was supposed to realign the auto feature. I had hoped that was it, but after doing that, it still skips after a little while of tracking freely.
|