For shift look at the 9-57 board for a 330 ohm.
Change it to a 1 watt film if it hasnt been.
Upright chassii with the 9-90 board have the same issue.
Recheck that you changed ALL the 22-5001 caps. I am
sure these had 5.
Check for a 1.5 ohm at the HOT base, they drift.
Be sure the hoz hold is centered. Pix should snap right in
on channel change & not show lines. If its at the end pull
back on the sleeve & move it past the stop.
I dont remember either size or centering on these.
And last it could be what you are feeding it.
73 Zeno
