View Single Post
  #31  
Old 08-11-2016, 06:27 PM
dr.ido's Avatar
dr.ido dr.ido is offline
VideoKarma Member
 
Join Date: Mar 2005
Location: SE Melbourne, Australia
Posts: 550
There is a PSON pin that turns the main power supply when it changes state. If it is 0V in standby connect it to the 5V standby rail via a 100 ohm or so resistor. If it is 5V in standby connect it to ground via the resistor.

From memory the PSON pin for these boards is on the larger connector next to the 5V standby pin and it goes to 5V when the set is on, but I don't have the board in front of me to check.
Reply With Quote