Quote:
Originally Posted by Electronic M
The 630 had the front of the CRT simply resting on a cutout in the front of the cabinet that it was installed through, and the neck supported by the yoke. A piece of styrofoam tall enough to keep the neck from being crooked in the yoke should be fine. For servicing the set on its side while opperating a IIRC 5XP4 test CRT is recommended...I don't gots one so I use an 8AXP4 or once in a while just use the 10BP4 it came with.... DuMonts and their licensees are nicer on the bench because they tended to integrate the face mount into the chassis.
|
Anything useful will be a bit hard to find, ( plug-in compatible ) that's not way overpriced
the closest thing I can find, so far is a 8KP4 at the ETF, same general wiring and biasing, & it won't roll off the table,
the only major dif, is electrostatic vs magnetic focus, & that most likely wont matter for repair.