View Single Post
  #12  
Old 01-04-2018, 08:49 PM
Crist Rigott Crist Rigott is offline
VideoKarma Member
 
Join Date: Oct 2015
Location: Waxahachie, TX
Posts: 1,506
Been busy over the holiday. Things have settled down a bit.
I re-stuffed C1 with 3 Nichicon 10k hour caps in the usual manner that I do.





Then I labeled all the components like I usually do.



I noticed that the 3 wires coming from the HV coil going to the Osc. 6V6 tube were hard and the insulation just crumbled away. So I'm in the middle of replacing those wires along with the HV wire going to the plate cap of the 1B3GT. That wire was cracking too.

Reply With Quote