Quote:
Originally Posted by DaveWM
the fact that the horz convergence is not responding (I think that is what you said) and the horz blanking may be causing the jail bars sure points to a problem there. Is the width ok? not too wide?
|
The horizontal convergence for the blue moves quite a bit, but just not in line with the other colors on the sides. There is the coil and two pots that move around the blue, but no combination of them will get the lines where they should be on the sides without messing up the top and bottom horizontal lines (center convergence stays put).
I've gotten used to no overscan, so this set's image seems too wide. I believe, though, that the overscan is about 6%. I can just see the edge of the 5% line on the overscan pattern.
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL
Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650
|