Quote:
Originally Posted by andy
If it has an LG panel, there are a pair of voltage regulator ICs under two large heat sinks which tend to fail Check the resistance between both sides of the blown fuse and chassis ground. If it's low, then you probably have a shorted IC.
You can replace the IC, but it's a difficult job due to the heavy circuit board traces. I've also had mixed luck getting good replacement ICs. I would recommend replacing the whole board if you can find one.
|
Thanks, Although when I looked at the panel (although I wasn't looking for it though either) it didn't seem like it said anything about LG on it, so maybe it is just a bad fuse? Or I guess I could just search on ebay and see if I can find that Y-Sustain Board and see if I can a replacement for cheap enough.