Quote:
Originally Posted by Electronic M
No need to remove the FP cans from the chassis....Just disconnect the positive terminal leads from the can and it will remain electrically dormant and preserve the original above chassis appearance.
|
I think I understand what you're saying. Leave it alone, disconnect it from beneath and put the new capacitor underneath. Neat idea. I have also read about rebuilding them and stuffing the new ones inside.
PS...If I forget the NOS Zenith stuff in the picture I will need the following:
1) 150uf-350v, 100uf-350v, 200uf-25v
2) 4uf-350v, 10uf-400v, 20uf-25v
I have been looking at all the major sites they don't seem to have capacitors with these three values each in 1 can. I was looking at that thread where the can went through the roof so I may want to avoid using the old and dried out NOS stuff after all.