View Single Post
  #3  
Old 01-03-2018, 12:00 PM
zeno's Avatar
zeno zeno is offline
VideoKarma Member
 
Join Date: Mar 2013
Location: New Hampshire
Posts: 4,672
For yoke straiten & push up til you get no neck shadow. Usually all
the way is fine.
For size & lin put up cross hatch or a big circle & adjust. You have to
go back & forth. Overscan the pix a little too. If you cant adjust
it right check the high ohm resistors near the controls & the electrolytic
in the cathode of the vert out.
AGC with strong signal turn up til it starts tearing, buzzing etc then turn
it back til it just stops.
If it has hoz size or lin do same as in vert.
Horz osc sometimes has a procedure.
Anything else should be handled as needed one part at a time.
DO NOT turn any coils !

73 Zeno
LFOD !
Reply With Quote