Quote:
Originally Posted by etype2
I tried with a soft cloth. I good try your meathod or maybe a Dremel tool with fine sandpaper, then seal with varnish?
|
The only way to get good results refinishing the brass is to remove the trim and work at it with successively finer grades of steel wool or scotch bright. The brass has a lacquer coating, that was sprayed on at the factory. Brasso will not do anything unless the brass is bare naked. Then Brasso can remove the tarnish. If you try to remove the lacquer coating using Brasso and a soft cloth, you will be expending many needless hours of labor
Removing the brass trim is easy. Behind the crt bezel you will find tensioning clips that hold the trim in place. Remove all the clips that hold the trim tabs in place. Then you can push the trim tabs forward, through the crt bezel and the trim frame can be easily removed.
If you try and clean the trim with Brasso with the trim in place, you will end up with Brasso in all the crevasses, and then there is still the problem of having to apply a new coat of clear lacquer to prevent future tarnish. No, varnish is not the correct product to use.
Click on the "Brass Refinishing" link under "MY Methods" section at my web site or click below
http://antiquetvguy.com/WebPages/MyM...finishing.html