Quote:
Originally Posted by old_coot88
If you had the coil assembly completely out of the can to work on it, how many wires did you have to disconnect/reconnect?
|
I just disconnected 2 wires and that was it, the wire that attached the IF can to the 1 Meg resistor and the grid cap wire which I had to disconnect to get the coil out of the can.
When I disconnected the grid cap lead I just went ahead and replaced the wire because the old grid cap wire was starting to disintegrate, and I tried to make sure the 2 wires connected back to where they were supposed to go by doing the wires one at a time.
So I don't know, the only thing I can think of is that maybe I accidentally disconnected one of the coil wires that went to one of the two terminals I removed the wires from.