|
Thanks for the thoughtful reply Findm. I tried leaving the function on rejuv for a few minutes before pressing the button. And I set my DMM to the 600V range (it's not an autoranging DMM).
No change. It peaks at just over 4 volts, stays there for a few seconds, and then drops by about 0.01 volts every 2 seconds.
The Remove G1 Short function, however, peaks at about 430 V, and then immediately starts to drop about 5V every second. And it doesn't require much time between tests to recharge. If I quickly re-press the button, then it peaks at 425, but after only a second between presses, it peaks at the original 430.
I can take a video if that's helpful.
edit: I waited for an hour with the switch at rejuv, no real difference. I think it may have peaked at 7V very briefly.
Last edited by spacediver; 12-18-2016 at 06:02 PM.
|