Quote:
Originally Posted by zeno
I think these are pretty much the same. If its bad I would try one
that looks the same but check the pin out. You need ground, +5v & data out.
73 Zeno
LFOD !
|
Different - in pinout and electrically.
Looking from the top of the sensor, OP's is a mirror pinout of mine - swap the pins around and it would work
if electrically the same, but.....his requires a "pullup" resistor (R3703 on his board), meaning it's a transistor output - the one I have is most likely a CMOS/FET output (direct connection to Standby 5V connection...). I was hoping....