View Single Post
  #6  
Old 08-08-2016, 05:18 PM
Electronic M's Avatar
Electronic M Electronic M is offline
M is for Memory
 
Join Date: Jan 2011
Location: Pewaukee/Delafield Wi
Posts: 14,762
looks good to me. Every so often the BTs will have bad lytics...Little cheap ones. If it has video hum (dark horizontal bar rolling slowly vertically, often disturbing V sync when it goes off screen) or other issues look at the caps.

If you go wired run it at or near minimum RF power (output level), and use a 75ohm to 300ohm balun/matching transformer to connect to the set. If you plan to go wireless crank the output level to max and look for a youtube video on antennas by shango66. Start with video and audio levels at min turn up till distortion appears then back down a bit. Audio carrier I typically set low to mid and make sure it is not creating buzz.

BTW: if you or anyone in a mile radius is using a DVT box for OTA reception transmit on an un-used channel so you don't jam other recievers....Come to think of it make sure your on an unused channel if you go wireless no matter what...I've had DTV interference with my TX experimenting on and near local channels.
__________________
Tom C.

Zenith: The quality stays in EVEN after the name falls off!
What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4

Last edited by Electronic M; 08-08-2016 at 05:22 PM.
Reply With Quote