Okay, I should have the 10x probe for the scope tomorrow. Here's a questions about testing the convergence board. I see in the Sams that each of the test points corresponds to a lead in the convergence socket. It would be much easier to test the leads if the socket were disconnected. That way I could touch the probe directly to each pin in the socket. That's where my question comes in. Is it okay to run the set with the convergence board disconnected. I know the convergence will be way off and there will be no power to the convergence magnets. Other than that, would I cause any damage to anything?
Thanks!
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL
Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650
|