|
Hi
I restored 3 of these a few years ago,I remember one had problems with the horizontal oscillator running off frequency and took a bit of adjustment with cap values to get it back.
From the picture the oscillator is running only just a little bit high though,from memory mine was very low.
I was told that with electrolytic caps at that time the stated value would be the minimum and could in practice be higher,never lower.
I managed to make some pcb connector extenders which would plug into the main chassis clear of the set and plug any of the boards into them enabling work on an individual board while the TV is running to be carried out which helped a lot.
Hugh
Last edited by Mr Hoover; 10-04-2011 at 05:11 AM.
|