|
These pictures are the results of where I'm at so far, image, quality wise. I still have to clean contacts in the tuner, tubes sockets, and pots. I changed the 108 ohm (measure) cathode resistor of the vertical output tube to increase the raster height. I'm able to get almost full crt coverage. I may have to make adjustments to the vertical linearity RC time constant yet. The set does not have a vertical linearity pot.
I may have to make up a new 16 inch diameter plastic insulator for the crt. The old one was cracked, allowing the semi circular steel threaded strap to ground out the 16AP4. Amazing this didn't cook the flyback.
Ed
|