|
Resistors are usually among the more temperature sensitive parts. Usually the best way to find a thermal sensitive part is to run the set till symptoms manifest and hit sections with freeze spray (or something similar like canned air) to see what makes it clear up. Start with general coverage of suspicious areas and once you get a good reaction to the spray, target specific components in the area of sensitivity to narrow it down.
Looking at the schematic you attached earlier I'm not seeing the -1.8 volts grid or 60V plate specs on either section of the 6AN8 sound IF/sync separator tube...Are you referencing a different listing of voltages? Also on multi section tubes like that one it is good to specify which section's plate and which sections grid when you say one is not right so we know which stage to look at.
|