|
A member on the other Forum asked if I checked the resistors that I replaced to see if they were out-of-tolerance.
On every restoration, I replace all the resistors 99% of the time. I log each resistor that was removed and each one that goes in. Just as a matter of record so to speak.
On this restoration with the IF and Main boards done, here is the tally.
IF Board:
14 resistors replaced.
6 were out-of-tolerance 43%
2 were close to being out-of-tolerance 14%
6 were within tolerance 43%
Main Board:
45 resistors were replaced.
31 were out-of-tolerance 69%
6 were close to being out-of-tolerance 13%
8 were within tolerance 18%
|