[Tube Radio]

I initially was getting no B+ voltage and the tube fiilaments were not very bright (string fed by B+) so I puzzled over it for awhile then I remembered I had taken photos of the back. I looked and yes I had forgotten a jumper wire to the first filter cap from the rectifier after a resistor. I now got correct B+, but still no sound. I then found one of my 35C5 tubes lost its vacuum. Once I get the two 35C5 tubes in the mail I will power up via isolation transformer, feed an audio signal generator to where the cartridge connects and using my oscope I will see where the signal stops. Given the way the PC board is (point tom point wired with wire and component leads) it could be anything from a component lead touching, a wire broken, ETC...