Quote:
Originally Posted by VintagePC
Would it be an idea to re-build the coil? I've calculated the length of damaged wire to be 5m, and I have the same fine stuff on hand.
Could it work, or would the new specs be different enough to require adjusting the set anyway? (what I'm hoping to avoid)
|
It will require alignment of the trimmer on the oscillator section of
the variable capacitor, but that's no big deal. IF
alignment (the slugs in the IF transformers) should not be affected.
Rebuilding the coil on its original cardboard core will probably
yield better results than trying to fit a 'universal' replacement coil.
By the way, the exact number of turns matters more than the length
of wire, so try to stay as close to original specs as you can. Also the
wire must be enameled (thin coat of varnish rather than bare wire
or wire with plastic insulation). This is often sold as 'magnet wire'.
Good luck!