|
|
|
#2
11-26-2014, 10:18 PM
|
|||
|
|||
|
As long you got power .I would check the belts first.Then I'll check the sensors on the side of the tape loading mech and the center photo diode/light sticking up in the middle of the tape mech.after that I would check the mech timing which could jump out of time.and then I'll check the mode switch.
I'm alittle confused as it spits out 30 minutes later. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode