Last post about my convergence

[DaveWM]

when you were checking those pots remember some of them may not test right in circuit. You would have to look at the schematic to see if they are isolated.

sometimes you have to comprimise the dynamic convergence, get one side perfect and the other is off a lot, in that case you shoot for the same defect on both sides. How much is normal and how much is a defect in a part can be hard to say. Just remember the idea behind dynamic convergence is to get the lines straight if thats done then it should be pretty close when the static is right on.

there was a post in the early color where a member (6GH8 cowboy IIRC) was having some convergence issues and it was bad caps. If I was have problems I would break out the scope and see if I could see the needed waveforms going to the coils. if they are there then it clear the parts as an issue so just focus on correct setup. Make sure you have all the neck parts in the correct position.