#16
|
||||
|
||||
Metal film is fine. On a SS set there is some risk going
with higher watt resistors. In some cases like the 330 ohm on your 9-57 ( also on 9-90 ) board need to go from 1/2 up to 1w due to a near 100% failure rate. One place you should never go up is low value resistors. They are often used as a fuse only. Newer sets use a lot of them. 73 Zeno |
#17
|
||||
|
||||
Quote:
So is there some kind of guideline with regards to resistor value and wattage? Is there a certain value where anything at or below it is usually a 1/4 and anything above it goes to 1/2 and more as the value increases? Or is value independent of the heat it dissipates? Must admit I'm learning lots lately. Once I get the Avanti up and fully functional, I'm taking what I've learned and giving the 19JC55Z chassis at thorough going over as well.
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650 |
|
|