|
|
|
|
|
#1
08-22-2018, 06:11 AM
|
||||
|
||||
|
Well I was hoping to get a consensus but it looks like people are are all over the place on this one.
I'd prefer an older CRT scope I think. What's everyone's opinion on the Fluke 3082? Will that do what I need it to? https://www.allaboutcircuits.com/tes...082/datasheet/ 
|
|
#2
08-22-2018, 11:42 AM
|
||||
|
||||
|
Quote:
|
|
#3
08-22-2018, 05:19 PM
|
||||
|
||||
|
Yeah, while I was piddling around thinking about it someone else bought it. 220 smackaroonies, looked like brand new with probes. Back to the drawing board.
|
|
#4
08-23-2018, 11:49 AM
|
||||
|
||||
|
Quote:
Remember that the more complicated something is, the more likely something will go wrong. As far as my experience, unless I was working on digital electronics (and then a logic analyzer is better) two channels on a scope is enough. Two channels allows you to compare the timing of two signals, you really don't do that very often on a TV. On some scopes the second channel is used for the X axis when displaying in the X-Y mode. For TV use a bandwidth in the 5 to 50 MHz is fine.
|
|
#5
10-11-2018, 08:27 AM
|
||||
|
||||
|
Just updating this to say I was patient and found a Tektronix TAS220 (the last of the analog scopes) with the readout function for 85 GBP. With shipping it cost me around 120€ total, plus 10€ for some new probes on Amazon and I'm all set. It seems to work perfectly, though I'm gonna check calibration before using it for anything important.
|
| Audiokarma |
 |
|
|
Hybrid Mode
