Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Diagnostic & Test Equipment

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 05-06-2018, 09:05 PM
Crist Rigott Crist Rigott is online now
VideoKarma Member
 
Join Date: Oct 2015
Location: Waxahachie, TX
Posts: 1,197
CRT Test Went South?

I got a Philco 49-1002 with a 10BP4 CRT. I hooked it up to my BK467 tester. At first there was no cutoff as expected. After a few minutes the cutoff started to work and the emissions started to climb. After about 5 minutes or so the needle was at the bottom of the green. I left it for about 15 minutes and when I came back, the needle was well into the green. Not quite mid scale into the green. Not bad.
I then hooked up my Beltron and after bringing up the filament to 6.3V I have good glow but zero emissions on the meter. What?!! I double checked the connections and the connector and the same thing. Zero, nada, zip.
I then hooked up the BK467 again, and set the filament to 6.3V (good glow), this time zero cutoff and zero emissions.
I'm perplexed. What happened? Anybody have any ideas?
Thanks.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:23 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
ęCopyright 2012 VideoKarma.org, All rights reserved.