#1
|
||||
|
||||
Packard Bell 17VT1 Audio
I thought this project was finished some time ago, but after reinstalling the chassis some new issues appeared. After putting on a test pattern I could see the vertical linearity needed adjustment. Also I couldn't control the vertical roll. My first concern, however, is an audio problem.
Audio sounds normal when the set is first turned on, but after a few minutes the sound deteriorates to a low-tone rumbling "Gro-o-nk, Gronk, Gro-o-o-nk." I'm looking at tubes first because any work with the chassis electronics requires removal of the CRT, which I dread. But which tubes might adversely affect the audio? Here's a link to a block diagram from Rider's: https://flic.kr/p/2nGpcxk And a link to the full schematic: https://flic.kr/p/24Z7cYP Other than snagging all the tubes that say "audio," I don't know which ones to be concerned with. Can anyone help me with that? Thanks. From Gary Larsen's The Far Side.
__________________
Winky Dink Damn the patina, Full speed ahead! |
|
|