|
It looks like the original arm had five holes, about 1/2" in diameter. Then the electric drill was invented, and they went nuts. I bought this about 10 years ago at a standard antique mall. No other similar items around. I think it would be easier to make a new arm out of sheet steel than it would be to repair that one to original look. Yes, even with the compound curves in the original. I do have CNC mill access where I could mill it nice and thin, but out of solid. Might be an interesting project... Could even go aluminum, even though it would still weigh a ton.
|
02-22-2018, 10:00 AM
Threaded Mode