Admiral Regent/C322C2 Score!

[old_coot88]

Originally Posted by SwizzyMan

...I do see what looks like silver getter material in the base though near the heaters of the guns.

A couple of questions - When you had the tester on it and got those unusually 'good' high readings, were the heaters glowing a nice healthy orange?

If not, was the neck around the gun area getting really, really hot really fast?

[SwizzyMan]

Originally Posted by old_coot88

A couple of questions - When you had the tester on it and got those unusually 'good' high readings, were the heaters glowing a nice healthy orange?

If not, was the neck around the gun area getting really, really hot really fast?

Seemed like the typical orange glow. Got really hot after about 10 mins. Hope it's not gassy?

[old_coot88]

Originally Posted by SwizzyMan

Seemed like the typical orange glow.

That's good. It's under vacuum. (If a jug has gone to air, the heaters won't glow, but the neck gets sizzling hot in half a minute due to conduction.)

Got really hot after about 10 mins.

That would be normal.

[SwizzyMan]

Originally Posted by old_coot88

That's good. It's under vacuum. (If a jug has gone to air, the heaters won't glow, but the neck gets sizzling hot in half a minute due to conduction.)


That would be normal.

Awesome! It should display a beautiful picture then.

[SwizzyMan]

I do intend to document almost everything I do while I restore this set both cosmetically and electrically. I am doing this to use it a reference and as a step by step series of the restoration of this set due to how rare it is. Next I decided to get the latex paint specks off of the tuning knob. It was a lot harder to remove the paint on the knob than it was on the cabinet due to the risk of harming the fragile plastic. I soaked the affected areas in olive oil to loosen up the paint and then used a pencil eraser to remove as much as I could. As you can see, I wasn't able to get all of it off, but it looks a whole lot better than it did.